Panamax and Furman Power Management now available at Safe and Sound

Panamax Furman Logo

Panamax Furman Logo

 

We at Safe and Sound, are please to announce the addition of Panamax and Furman Power Conditioners and Surge protection products to our product line. For over 30 years, Panamax and furman have been recognized as the leader in power management and surge protection for your home audio equipment.

The typical surge protector or power strip in reality offers very little protection. In addition, they do not filter or clean contaminated power at all. For the highest level of sound performance and purification, a power conditioner is the best addition to your home audio system.

All audio enthusiasts strive for the ultimate performance out of their equipment and system and this is where power conditioning and surge protection plays a key role in achieving this. Now, more than ever, audio has become more detailed and dynamic.  Modern A/V Receivers and power amplifiers, being more powerful, have increased power output and demand more power.  In short, today’s music sources and blu ray movies demand more current. For example, a large explosion in a movie will result in a sudden large draw of current to reproduce the signal accurately. This results in the power amplifier or receiver’s power supply being used over capacity and dropping to a very low impedance. Furthermore, the equipment will attempt to stabilize and, by doing so, the current is compressed and the end result is lower quality audio. Current compression can result in greatly reduced fidelity, frequency response, and transient volume level of the signal that is being reproduced, leaving the content sounding boomy, flat, dull, and listless. By providing a current reservoir at the AC source immediately in front of the power amplifier, a short duration current reserve is readily available . This provides control, bottom-end extension, and increased dynamics when the power amplifier is pushed to higher volume levels.

Panamax and Furman Power Conditioners are an excellent addition to any home theater or home audio system as they provide the following performance upgrades:

Voltage Regulation

Improve system performance and prolong equipment life by providing a consistent level of optimal power to your equipment.

Improves Picture and Sound Quality

Level 4+ Power Cleaning and Filtration eliminates common symptoms of contaminated power (including loss of detail, pops, hisses, hums and visual artifacts) and allows your A/V equipment to perform up to its full capability.

Monitors Incoming Line Voltage and Provides a Visual Indication of Power Level

Panamax’s patent pending AVM™ circuitry continuously monitors the incoming power as displayed on the digital voltmeter. In case of an under-voltage or an over-voltage, a flashing lightning bolt will be displayed in red in the voltmeter, and power to the connected equipment is automatically turned off if either of these conditions is detected. When voltage returns to a safe level, power to the equipment is automatically reconnected.

Reduces Cross-Contamination Between Components

Panamax and Furman power conditoners provide noise isolation between 5 isolated outlet banks including 2 high current outlets so that any noise created by an A/V component can not contaminate the power going to equipment plugged into another outlet bank.

We encourage our customers to reach out to us either by live chat, email, or phone and we can address the recommended Panamax or Furman power conditioning and surge protection products suitable to your home theater or home audio system.

  , , , , , , ,


Leave a Reply

Your email address will not be published. Required fields are marked *